• 53mm total length, 15mm splined section

• Ideal for fitting aftermarket wheels/spacers

• Ensures safe installation with 14mm of thread engagement

The Press-In Wheel Stud is a high-quality, essential component for safely fitting aftermarket alloy wheels or spacers when the original studs are too short. Supplied individually, each stud measures 53mm in total length, featuring a 15mm splined section, 30mm of threaded portion, and an 8mm blank outer end. This precise design ensures a secure fit when pressed into hubs that already have factory-installed studs.

It’s crucial to measure the stud length carefully for your specific application. After installation, make sure there’s at least 14mm of thread engagement to ensure proper fitting of the wheel and/or spacer, providing the necessary strength and safety for your vehicle’s wheels.