Pertronix Ignitor III Kit Vacuum Advance 12v: Beetle (1971-1979), T2 Bay (1971-1979), Karmann Ghia (1971-1974)
Pertronix Ignitor III Kit Vacuum Advance 12v: Beetle (1971-1979), T2 Bay (1971-1979), Karmann Ghia (1971-1974)
Reviews & Ratings
The Ignitor III ignition module is designed for the serious performance enthusiast who demands serious power. You have seen the performance increases the Ignitor and Ignitor II series of electronic ignitions have brought. Now get ready for more... 5 times more spark energy than a typical points system. Ignitor III modules provide ignition box performance... without the ''box''! For the maximum Ignitor III benefit, select one of the Flame-thrower III or Hc ignition coils from the coil section.
FEATURES
• Multiple sparks thru the entire rpm range.
• Integrated digital rev limiter with LED feedback for precise rpm setting.
• Memory safe function stores settings eliminating unintended changes to rev limit.
• Adaptive dwell maintains peak energy throughout the entire rpm range, reducing misfires while improving engine performance.
• peak current level is reached just prior to spark for maximum energy without the heat build-up, increasing coil performance and module reliability.
• Adjusts spark timing at higher rpms to compensate for the inherent electronic delay.
• Senses start-up and increases energy for quicker, easier starting.
• Thermal clad surface mount construction for superior reliability.
• Built-in reverse polarity and over current protection shuts down the system, preventing component damage.
Must be used with Ignitor 3 coil AC90544001
Klarna now available in checkout
Product Information
Also known as | AC99871847V |
---|---|
Fitting Info | The Ignitor III is a high performance ignition system, and although the installation is not complicated, there are some specific requirements. For optimal performance the Ignitor III requires a minimum of 12 volts. vehicles equipped with a resistance wire or ballast resistor, should be modified as outlined in the instruction manual. . Timing must be reset when ignitor 3 is fitted. . 12 volt negative ground systems . Requires 12-14 volts . Must use suppression core ignition wires . Not for use with cD or multiple spark systems . lobe sensor design triggers off the point cam or reluctor and does not require a magnet sleeve |
Marque | Volkswagen |
Vehicle | Beetle, Type 2 Bay, Karmann Ghia, Beetle Cabriolet, Type 3 |
Brand | Pertronix |
Quality | Top Quality |
Unit of sale | Kit |
Standard or Upgrade | Upgrade |
Supplier code | 71847V |
Weight | 1.00 |
Fits Vehicles
Beetle | 1971-1979 |
---|---|
T2 Bay | 1971-1979 |
Karmann Ghia | 1971-1974 |
Beetle Cabrio | 1971-1979 |
Type 3 | 1971-1973 |