gas pedal Chassis Repair for Right Hand Drive: T2 Bus (1968-1972)
gas pedal Chassis Repair for Right Hand Drive: T2 Bus (1968-1972)
Reviews & Ratings
If you have a Right Hand Drive Early Bay you will possibly have a sloppy throttle rod that goes through your chassis, over the years people have possibly welded on washers to reduce the play. With this kit you can fit a new bearing onto your original rod, so do away with the play and give you zero slop.
Buy NOW, Pay LATER
Klarna now available in checkout
Warning
This product, and the activities for which this product is intended (including operation, servicing and maintenance of a passenger vehicle or off-road vehicle) can expose you to chemicals including engine exhaust, carbon monoxide, phthalates, and lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to https://www.p65warnings.ca.gov
Product Information
Also known as | AC721013 |
---|---|
Fitting Info | Will fit RHD Baywindow from 68-721) Remove the roll pin that holds the end piece on2) Then the end piece should just pull off , this part may come straight off , or may need heat to remove it3) Once end piece is off clean the shaft up using some sandpaper\/wet and dry paper to clean off the corrosion, until the bearing slides over. (Slide bearing and holder up to the section thats worn4) Using the bearing holder mark through the 2 outer holes, then drill 2 holes and bolt the plate on5) Lubricate the shaft and fit the new end piece and secure in place with the supplied roll pin. Then remount the throttle kit |
Marque | Volkswagen |
Vehicle | Bay Bus |
Brand | Buttys Bits |
Quality | Top Quality |
Unit of sale | Each |
Weight | 1.00 |
Fits Vehicles
T2 Bus | 1968-1972 |
---|