SIGN UP TO OUR NEWSLETTER

+1 (833) 595-9193

Brake Dual Master Cylinder Conversion Kit: Split Bus (1960-1967)

SKU
AC698015

Brake Dual Master Cylinder Conversion Kit: Split Bus (1960-1967)

SKU
AC698015
Reviews & Ratings

Dual circuit master cylinder conversion kit (master cylinder not included). This kit is used to bolt a late dual circuit master cylinder (our part number 211-611-021AA) into a >67 T2. The kit includes a billet adaptor + bolts and a brake fluid reservoir.

Was $139.95 $139.95 Now $125.54 $125.54

Need help?

Contact us


Buy NOW, Pay LATER

Klarna now available in checkout


Only 1 Available
HPC

Warning

This product, and the activities for which this product is intended (including operation, servicing and maintenance of a passenger vehicle or off-road vehicle) can expose you to chemicals including engine exhaust, carbon monoxide, phthalates, and lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to https://www.p65warnings.ca.gov

Product Information

Product Attributes
Also known asAC698015
Fitting InfoFor upto 1966 and 1967 euro spec non servo brakes with a dual master cylinder: The rear brake line and brake light switch are fitted to the front two ports closest to the push rod. You should have two front brake lines, one to each of the left and right front brakes. These fit to the two rear ports on the dual circuit cylinder. For 1967 US buses non servo brakes with a dual master cylinder: The rear line is fitted to one of the front ports closest to the pushrod. The front line is fitted to one of the rear ports. There are 2 brake light switches one in the front port and one in the rear port. Check the rod that goes into the master cylinder from the pedal. It should have an 1\/8 inch of play before, you can feel the rod make contact with the plunger If there is no play - the plunger will not come back far enough to let the fluid into the cylinder - If it has too much play you will be pushing the pedal down a long way before the master cylinder even does anything. To adjust undo the jam nut on the pushrod and change the length, then do the nut back up. PLEASE NOTE IF YOU HAVE AN ORIGINAL PEDAL PAN THIS WILL NO LONGER FIT DUE TO THE EXTRA LENGTH OF THE NEW MASTER CYLINDER.
MarqueVolkswagen
VehicleSplit Bus
BrandHeritage Parts Centre
QualityTop Quality
Unit of saleKit
Weight1.00

Fits Vehicles

Product Vehicle Years
Split Bus1960-1967

Product Questions

No questions yet. Be the first to ask the question!

You may also like