SIGN UP TO OUR NEWSLETTER

+44 1273 444000

Accelerator Pedal Linkage Kit for Right Hand Drive: T2 Bay (1968)

SKU
AC721007

Accelerator Pedal Linkage Kit for Right Hand Drive: T2 Bay (1968)

SKU
AC721007
Reviews & Ratings

This accelerator pedal linkage upgrade kit from Buttys Bits for VW Baywindow 1968 right hand drive converts your throttle pedal from a worn vague on/off switch to a smooth progressive control and transforms the driveability of your bus.

This kit is the main wear area on 1967-1969 busses, the kit mounts to the throttle pedal then goes down through the cab floor to the main swivel section, these kits have sealed roller bearings that allow everything to rotate nice and smoothly. Kit also has a double ended rose joint rod that if you feel needs adjusting you can.


The kit has recently been uprated with a NEW stainless steel top hat section (That`s the part that is usually welded to your floor that the kit bolts to ) These come as standard with every kit , you will need to remove the original steel mount then bolt this stainless mount up in its place . Comes with 4 stainless steel bolts nuts and washers .(Just make sure when bolting up , the push rod from the pedal is centred in the hole in the floor) it will be if the plate is centred over the large hole .


If you look at the image with the mounting plate with the large hole in this as you would look down on the kit installed on your cab floor , this image will help you work out positions of the holes . Lay the plate down inside cab on the floor as the image then drill through the plate .

Also these joints are encased inside a rubber boot to keep all the crud and dirt out as your front wheel is situated right behind the joint.

Plus there is now a tiny 8mm spanner included in the kit, to be used when fitting the small balljoint to the throttle pedal (doesn’t seem much but an absolute time saver, believe us).

Regular Price €115.97 €99.12 Now €104.17 €89.03

Need help?

Contact us


Buy NOW, Pay LATER

Klarna now available in checkout


Delivered within 2-3 weeks
Buttys Bits

Product Information

Product Attributes
Also known asAC721007
Fitting InfoThe kit consists of: A laser cut 5mm steel replacement pivoting linkage complete with sealed ball bearing swivel section Upgraded linkage from the pedal with bolted rose joints Rose jointed link rod return spring & mounting hardware When bolting the end of your throttle cable to the linkage, tighten then undo by a half turn to allow the cable to rotate freely. Use the supplied return spring if the kit is being used with a standard carburretor. Twin carburretors will have their own return springs which are stronger than stock springs.
MarqueVolkswagen
VehicleType 2 Bay
BrandButtys Bits
QualityTop Quality
Unit of saleKit
Standard or UpgradeUpgrade
Weight1.00

Fits Vehicles

Product Vehicle Years
T2 Bay1968

Product Questions

No questions yet. Be the first to ask the question!